GAS MONITORS




PORTABLE MONITOR

The Series C16 PortaSens II portable gas leak detector includes the unique feature to measure a variety of different gases by simply inserting the appropriate sensor for that gas.

How it works

This one handed operated gas detector provides the ability to perform regular checks in gas storage areas, around process equipment and piping, or in confined spaces prior to entry. The sample pump and flexible sampling wand allows the source of the leak to be identified.

Interchangeable smart sensors – the versatile nature allows the detection for over 30 gases; Bromine, Chlorine, Chlorine Dioxide, Fluorine, Ozone, Iodine, Ammonia, Carbon Monoxide, Hydrogen Chloride/Cyanide, Oxygen, Phosgene, Nitric Oxide, Nitrogen Dioxide, Sulfur Dioxide, Arsine, Diborane, Germane, Phosphine, Silane, Ehtylene Oxide, Formaldehyde, Alcohol, Acetylene, etc.

Features and Benefits:

Hand held gas detector – contains an internal sample pump and a flexible sampling wand to allow pinpoint location of the source of leakage.

 

Large LCD display – the measured values are easily visible via the LCD display, which features a back-light for readability in low or no light conditions.

 

Data storage – it is equipped with an RS-232 output, allowing stored data to be downloaded to a PC through the supplied interface cable and software package


STATIONARY MONITOR

The GasSens stationary gas monitor is a flexible component able to meet individual gas detection and alarm requirements. It can be used in chemical and petrochemical plants to food processors, providing a reliable leak detection and low maintenance.

How it works:

The individual receiver modules are the basis for the detection and alarm system. Each compact module includes a digital display of gas concentration, isolated analog output, and 4 relay outputs.

Receivers may be located up to 1000 feet from sensor/transmitters for remote indication, or can provide local control functions such as valve shutoff while transmitting a 4-20 mA signal to remote displays or data loggers.

Features and Benefits:

Low maintenance – the automatic sensor testing system reduces operator testing requirements.

 

LED display – the display indicates the gas concentration directly in PPM, PPB, or a percentage. It also comes with a backlight for low visibility conditions.

 

Remote Reset Input: Terminals are provided for connection of a remote reset switch so that alarms can be acknowledged from a remote location or through a telemetry system.


WET MONITOR

The wet H2S gas monitor utilised specially developed sensor technology allowing the continuous monitoring of hydrogen sulphide in both inlet and discharge air, where condensing humidity conditions are normal.

How it works:

The odour monitoring system uses the Q45 electronics package in conjunction with a special “Wet H2S” sensor.

Measurements may be made either at the inlet to scrubber systems where concentrations can run as high as 200 PPM, or at the outlet where concentrations are ideally down below 0.5 PPM.

Special sensor configurations are available for either duct insertion or flowcell use.

Features and Benefits:

Special Wet H2S Sensors:  The system utilises a special sensor designed to operate in condensing gas streams without the water vapour blinding typical of standard sulfide sensors